野花香高清在线观看视频播放免费,国产aⅤ无码专区亚洲av,色偷偷色嚕噜狠狠网站,人人妻人人澡人人爽欧美精品

第一步：對墻面進行平整預處理，中間要用到，尺子、切割機、錘子、釘子。
The first step: the surface of the smooth pretreatment, in the middle to use, ruler, cutting machine, hammer, nails.
注意點：墻面要做到平整，有坑洼的地方使用發(fā)泡膠填充，或者直接打上木架。
Note: the wall to achieve smooth, eliminate the use of styrofoam filled, or a direct hit on the gallows.
第二步：根據實際尺寸進行仿大理石裝飾板的切割。
The second step: according to the actual size of the imitation marble decorative plate cutting.
注意點：在拼接的過程當中要從一邊開始，不限制那邊，邊緣根絕實際尺寸裁剪。

Note: in the splicing process should start from the side, does not limit the side edge according to the actual size of cutting.
第三步：將拼接好的板材取下，然后用結構膠進行涂抹。兩種涂抹方式1.全部均勻的整板涂抹。2.定點涂抹。
The third step: the splicing of a good plate removed, and then use the structural adhesive for painting. Two all the way to apply 1 evenly coated. 2 fixed point smear.
注意點：在涂抹的時候盡量均勻，避免不平整的結合！
Note: in the smear of the time as far as possible to avoid uneven combination!
第四步：邊緣和仿大理石線條搭配使用，能夠使設計的整體效果更加完美！
The fourth step: the edge and the imitation marble line with use, can make the design of the overall effect is more perfect!
注意點：不能畫蛇添足，根據場合進行使用。
Note: can not use superfluous, according to the occasion.
第五步：修邊機的使用。這個過程看的就是師傅技術了，有一些年輕沒經驗的師傅修邊做的非常糟糕，影響整體的效果。
The fifth step: the use of trimming machine. This process is to see the master of technology, there are some young and inexperienced master to repair the edge of the very bad, affecting the overall effect.
注意點：盡量找個有經驗的師傅去做這個工作。修邊會做到錦上添花的效果。
Note: try to find an experienced teacher to do the work. Trimming can achieve the effect of icing on the cake.
第六步：最后撕去仿大理石UV裝飾板材飾面的防護膜。
The sixth step: the last to tear off the imitation marble UV decorative plate facing the protective film.
注意點：不要用利器去除去封膜，慢慢的用手揭開封膜。
Note: do not use the weapon to remove the film, slowly open the sealing film.
。